Starting principle of roller press after jump stop
Posttime£º2017-10-20 14:27:38 Read£º673
The start of the roll press must follow the following guidelines:
1, roller press after jumping, should immediately hit the bypass production, to prevent too long time to shake.
2, as a result of "roll gap fault" jump according to the following steps:
a hydraulic jack at the same time on the roller press drive side, non-drive side pressure (pressure can not exceed 10000), hydraulic jack pressure at the same time, the need for manual pressure roller press, roller roll on both sides of the roll seam To more than 23mm.
b, roll seam top open, the scene manually open the roller, set the roller rotation, the motor power to be
50KW or less, before stopping (such as the set roller does not turn, should be shut down and the hydraulic jack will roll the roof is greater).
c, set the roll after the rotation, hit the central control position, starting by the control and with the material production.
3, as a result of "dry oil system alarm" jump, the mill manager should immediately check the dry oil system (1, the phenomenon: no oil inside the barrel measures: charge 2, the phenomenon: dry oil distributor block measures: And there is a written record in the shift record.
4, other reasons to jump, by the central control operator phone promptly notify the workshop director of the above management personnel, on-site processing.
1, roller press after jumping, should immediately hit the bypass production, to prevent too long time to shake.
2, as a result of "roll gap fault" jump according to the following steps:
a hydraulic jack at the same time on the roller press drive side, non-drive side pressure (pressure can not exceed 10000), hydraulic jack pressure at the same time, the need for manual pressure roller press, roller roll on both sides of the roll seam To more than 23mm.
b, roll seam top open, the scene manually open the roller, set the roller rotation, the motor power to be
50KW or less, before stopping (such as the set roller does not turn, should be shut down and the hydraulic jack will roll the roof is greater).
c, set the roll after the rotation, hit the central control position, starting by the control and with the material production.
3, as a result of "dry oil system alarm" jump, the mill manager should immediately check the dry oil system (1, the phenomenon: no oil inside the barrel measures: charge 2, the phenomenon: dry oil distributor block measures: And there is a written record in the shift record.
4, other reasons to jump, by the central control operator phone promptly notify the workshop director of the above management personnel, on-site processing.
