The reason why the hoist is not fully uninstalled
Posttime£º2017-10-20 08:57:45 Read£º594
Provided machine material is not completely unloaded at the unloading position, to enhance this phenomenon caused the material base of a machine is also called back, if the elevator will feed back too much, low consumption, energy consumption and increase the rate of broken material.
There are many reasons why the unloading position is not completely uninstalled. Here is the reason why the hoist is unloaded when unloading:
1) the operation speed of the hopper is too fast, because the hopper running speed is different: individual dry powder and granular material, the speed is about 1 m / sec ~ ~; lifting block material, the speed is 0. 40. 6 m / sec; wet powder cone crushing material, the speed is 0. 60. The speed of 8 / sec through the early formation of large unloading, feedback. This should be based on the nature of the material in the hopper, appropriate modification speed, to prevent backflow material.
2) die unloading plate installation discomfort, tongue plate from the funnel discharge position is too far, it will form a return material. The position of the tongue plate should be adjusted in time to prevent the backflow of bucket elevator.
There are many reasons why the unloading position is not completely uninstalled. Here is the reason why the hoist is unloaded when unloading:
1) the operation speed of the hopper is too fast, because the hopper running speed is different: individual dry powder and granular material, the speed is about 1 m / sec ~ ~; lifting block material, the speed is 0. 40. 6 m / sec; wet powder cone crushing material, the speed is 0. 60. The speed of 8 / sec through the early formation of large unloading, feedback. This should be based on the nature of the material in the hopper, appropriate modification speed, to prevent backflow material.
2) die unloading plate installation discomfort, tongue plate from the funnel discharge position is too far, it will form a return material. The position of the tongue plate should be adjusted in time to prevent the backflow of bucket elevator.
